NO DIE MARK BENDING
QViPVjDIE WING BEND
DIE MARK OCCURS AFTER BENDING. LITTLE DIE MARK OCCURS DUE TO THE GENTLE BENDING
THE COVERED VINYL IS TORN AND
THE DIE MARK OCCURS AFTER
BENDING ALUMINUM AND
STAINLESS STEEL.
NO DIE MARK OCCURS
FOR BENDING SUCH AS
ALUMINUM, STAINLESS STEEL AND THE COVERED MATERIALS.
THE COVERED VINYL IS NOT TORN.
YOU CAN GET YOUR
REQUIRED ANGLE BECAUSE OF NO USAGE OF URETHANE SHEET.
THE URETHANE SHEET IS PUT ON
THE DIE TO PREVENT DIE MARK, BUT
YOU HAVE TO CHANGE IT
INTO NEW ONE EVERY 10-20
BENDING CYCLE TIMES.
THE PRODUCTIVITY GOES DOWN AND
IT COSTS HIGH.
THE BENDING ANGLE CHANGES EVERY BENDING.
LITTLE DIE MARK OCCURS FOR
BENDING SUCH THE PRE-PAINTED
MATERIAL.

|TOP PAGE|